WWW.RUSTY22.COM
  The BMT - Buckmark Maintenance Tool
 
   
 
 
 
 
 
So how many of you guys carry a toolbox to the range???

if you don't, you have not yet had a lesson in MURPHY"S LAW while at the range. believe me, one of these days you will.

if i'm in for an "extended" session (8 hours +) at the range, my "trusty" shooter's toolbox is on the "MUST BRING" list. then there are times when a QUICK visit to the range is all that is needed or allowed for because of time. when this is the case, lugging a full size toolbox might be a little OVERKILL and UN-NECESSARY.

though a well designed pistol, the buckmark CAN, if preventive measures (applying threadlocking compound on a couple screws) are not taken, go from running like a race car to running like a "clunker". most of the time, the "culprit" to some of your troubles during your range session is a mere screw beginning to loosen up.

here's a little "WIDGET" i came up with for those times when carrying a FULL toolkit is not practical.
 
 
BUCKMARK MAINTENANCE TOOL 3/32 HEX BIT  
 
     
3/32 HEX BIT FOR INSTALLING AND REMOVING FRONT AND REAR SIGHT BASE SCREWS:   SAME BIT CAN BE USED FOR THOSE WHO'VE SWITCHED TO ALLEN TYPE GRIP SCREWS:
     
3/16 SLOTTED BIT FOR ADJUSTING PRO-TARGET SIGHTS: ELEVATION AND WINDAGE ADJUSTMENT:  
     
THUMBSAVER / MAG LOADER    
 
     

SPRING RETAINER CHANNEL

this feature on the tool allows you to EASILY remove the slide (models with firing pin assembly blocks) WITHOUT BENDING OR DAMAGE TO THE RECOIL SPRING ROD.